Edelbrock 2696 Carburetor Spacer Four-Hole Square-Bore to Spread-Bore for Quadrajet & Thermo-Quad Manifold Base 0.85In Venturi

Fitment

This adapter plate will allow you to use an Edelbrock square-bore carburetor on a stock Q-jet or Thermo-Quad intake manifold with a spread-bore flange

Item specifics

Carburetor Adapter Plate Model or Series: Square Bore Spread Bore

Carburetor Adapter Style: Individual Ports

Carburetor Adapter Material: Aluminum

Carburetor Adapter Finish: Natural

Carburetor Adapter Height: 0.850″

Carburetor Base Flange: Square Bore

Intake Manifold Flange: Spread Bore

Adapter Style: Individual venturi ports

OEM Part Number：2696

Thick: 0.850 inches

Notes: To use the threaded vacuum port on this adapter an 1/8 in. hole must be drilled in each of the rear

venturies to open the flow of vacuum to the port.

Purchase Note：

The carb adapter will raise the carburetor by over 3/4” and some air cleaners will require additional spacers for carburetor
clearance, especially on carbs with electric chokes. The total height (carb spacer plus air cleaner spacer) must be calculated and
hood clearance checked before proceeding with your installation. Check air cleaner-to-hood clearance by placing several large clay
posts at various points on top of your air cleaner, then close the hood to compress the posts. Measure the thickness of the clay posts
to ensure that adequate clearance exists.

This kit will also work on manifolds designed for the Thermo-Quad carburetor. It contains the necessary items to adapt the EPS carb to the OEM manifold. #2696 is emissions legal when used with carburetor #1400 on a 1980 and older non-feedback GM vehicles powered by a V8 gasoline engine.

Package:

1Sets X Carburetor Kits (Same as our photos show)